A digital display pressure transducer for air extraction use to measure negative pressure difference of air inlet over a range of 0 to -15 psi g from a 1/4 NPT male process connection, and sending the corresponding 0-10Vdc signal through the DIN plug electrical connection.
This DS 200 negative gauge range pressure transducer can be used in air fans and blowers for extracting dust and fumes to measure negative air pressure from 0 to -15 pounds per square inch gauge.
The transducer is installed using a 1/4 inch NPT tapered male thread to measure the air, and the 0 to 10 volts dc analog output is connected to signal monitoring instrumentation using the DIN plug pin connector.
SKU ID: s1-ds200-78-19624
Pressure Range: 0 to -15
Units: psi
Range Type: Negative Gauge/Suction (atm to -P)
Output Signal: 0-10V (3 wire)
Accuracy: 0.35%FS 0.4 bar range min, 0.5% below (11-12bit resolution)
Switch Output: None
Electrical Connection: DIN plug (0-10V 3 wire only)
Process Connection: 1/4 NPT male
Process Connector Material: Stainless steel 316L
Diaphragm Material: Stainless steel 316L
Media Exposed Seals: FKM